User's Manual

Network/

USB memory

[Wired LAN settings]

<DHCP>

If you set DHCP to Use, the IP address of the projector is assigned automatically by the

DHCP server. If your network environment does not assign IP addresses automatically,

set DHCP to Not use, then set the following items IP address, Subnet mask and

Gateway manually.

When DHCP is set to Not use, consult with your network administrator for the settings

below and set the IP address manually.

An IP address is a unique number assigned to a terminal. The format is a string of four

dot-separated three-digit numbers. (Example: 111.112.xxx.xxx)

Note: If you set the same IP address for wireless LAN with the one for wired LAN,

network function may fail to operate properly.

A subnet mask is used to determine what subnet the IP address assigned to a terminal

belongs to. (Example: 255.255.xxx.xxx)

Note: If you set the same subnet work for wireless LAN with the one for wired LAN,

network function may fail to operate properly.

This value speciﬁes the IP address of the device, such as a router, to be used to access

servers outside the network. (Example: 111.112.xxx.xxx)

[Application]

Browser authentication

Browser authentication and Password are factory-set to Off and no string,

respectively. You should set them as soon as possible.

Password

If you have forgotten your password, set it again using the menu on the main unit.

•