User's Manual

79
Network/
USB memory
Operating the projector
This function can be used with any projector input.
1
Launch the Network Utility software application.
The Screen Image transmission mode window appears on the computer’s screen.
2
Click the Remote
Control button.
The Remote Control window
appears.
As the Network Utility window is
still displayed, you can operate the
projector via the Remote Control
window, while using the Network
Utility’s functions.
While it is possible to use this function merely to operate the projector, closing the
Network Utility also closes the Remote Control window.
3
Select the projector to be operated.
In the Remote Control window, click the button, and select the
desired projector from the pull-down list. When you make a selection, the
Remote Control window displays as shown in the right figure.
Only one projector can be selected. (It is not possible to operate multiple
projectors.)
4
Click the Remote Control window’s buttons.
The function of each button and box is as follows:
Power On: Turns projector power on.
Power Off: Turns projector power off.
Freeze: The picture is paused.
Input (box): Click the button, and select the desired input from the pull-down list.
Go: Switches to the input selected in the Input box.
Mute: Cuts off picture and sound. Click again to restore picture and sound.
Volume +/–: Adjust sound volume.
Resize Off Restores the picture to its original size.
Resize +/–: Adjusts the enlargement ratio.
: Move screen (up/down/left/right/diagonal)
5
To quit, click the button on the Remote Control window.
Performing this does not close the Network Utility window.
To exit both the Network Utility and the Remote Control, click the button on the
Network Utility window.
