User's Manual

96
Trouble indications
The indicator illuminates and a beep sounds to inform you of internal abnormalities.
No power
⇒
Problem with projector
Unplug the power cord, and contact your sales representative.•
Lamp went out during use, or won’t come on
⇒
Lamp temperature is high so that it is difficult to turn on, the
lifetime of the lamp has ended or the projector is malfunctioning.
Unplug the power cord and wait for a short while, then turn the
power back on.
If a lamp burns out, replace it with a new one.
•
•
Power went out during use
⇒
Internal overheating, or the outside temperature is too high.
Make sure the projector is placed so that the air intake and
exhaust are not blocked.
Unplug the power cord and wait for a short while, then turn the
power back on.

The icon will appear before the power goes out.
•
•
Power went out during use
⇒
Problem with internal cooling fan.
Unplug the power cord, and contact your sales representative.

The icon will appear before the power goes out.
•
Power went out during use, or power won’t come on
⇒
The lamp cover is not properly attached.
Unplug the power cord, and reattach the lamp cover.
p.92
•
Power went out during use
⇒
Problem inside the projector.
Unplug the power cord and wait for a short while, then turn the
power back on.
If the above action does not clear the problem, unplug the power
cord, and contact your sales representative.

The icon will appear before the power goes out.
•
•
Note
After there is an abnormal indication, the abnormal status remains until the power cord
is unplugged.
•
Others
(OFF)
(Red
flashing)
(Red lit)
(Red lit)
(Red lit)
or
(Red
flashing)
(Red lit)
(Green
flashing)
(Red lit)
(Red lit)
(Red lit)
(Orange
flashing)
(Orange lit)