Service manual

Engine Disassemble Procedure
SM 4-83 M085/M086
Replacement
and
Adjustment
2. Remove the Taptite bind B M4x12 screw [A], and then remove the SW holder [B] from the
Main body.
3. Remove the Taptite pan (S/P washer) M3.5x6 screw [C], and then remove the FG harness
ASSY [D] of the Inlet harness ASSY [E] from the LV shield plate 2 [F].
4. Remove the two Taptite flat B M3x10 screws [G], and then remove the Inlet harness ASSY
[E] from the Main body.
5. Remove the two Taptite cup S M3x6 SR screws [H], and then remove the LVPS PCB unit [I]
from the LV shield plate 2 [F].
6. Remove the two Edge holder 3 [J] from the LV shield plate 2 [F].
7. Disconnect the Connector [K] from the LVPS PCB unit [I].