Service manual

Maintenance Mode

M085/M086 5-38 SM

Acquisition of White Level Data (Function code 55)

This function allows the machine to obtain white level data for the CIS unit and save it into the

EEPROM on the main PCB.

 If you replace the FB unit, be sure to carry out this procedure.

1. <M085>

Press the 5 button twice in the initial stage of the maintenance mode.

Press the

or button several times. "MAINTENANCE 55" appears on the LCD, and

then press the OK button.

"Press START" will appear on the LCD.

2. Press the Start button.

"SCANNER AREA SET" will appear on the LCD.

The machine saves the revision data into the EEPROM after a few seconds. Then, it beeps

for one seconds and returns to the initial stage of the maintenance mode.

Paper Feeding and Ejecting Test (Function code 67)

This function allows you to check that a sheet of paper is fed and ejected correctly by printing

the grid pattern on a page, whose interval is 1cm.

1. <M085>

Press in order the 6 and 7 buttons in the initial stage of the maintenance mode.

Press the

or button. "MAINTENANCE 67" appears on the LCD, and then press the

OK button.

2. The "PAPER FEED TEST" will appear. The test printing is started, and the grid pattern is

printed.

3. Press the Stop/Exit button so that machine stops printing. Then, it beeps for one second

and returns to the initial stage of the maintenance mode.

 In the case that the front cover is opened, or that there is no paper in the tray during

test printing, the test printing is stopped.

 Continue being printed till the recording paper disappears as far as push the Stop / Exit

button or open the front cover.