Service manual

Worker Switch Settings (WSW)
M085/M086 5-76 SM
 Selectors 1 through 4: Frequency band selection for incoming calling signal (CI)
These selectors are used to select the frequency band of CI for activating the AUTO ANS
facility.
In the French models, if the user sets the PBX to OFF from the control panel, the setting
made by selectors 1 and 2 will take no effect and the frequency's lower limit will be fixed to
32 Hz. (Even if the setting made by these selectors does not apply, it will be printed on the
configuration list.)
 Selectors 5 through 8: No. of rings in AUTO ANS mode
These selectors set the number of rings to initiate the AUTO ANS facility.
5.3.16 WSW15
Selector No. Function Setting and Specifications
1
2
Redial interval
No. 1 2
0 0 : 5 min.
0 1 : 1 min.
1 0 : 2 min.
1 1 : 3 min.
3 to 6 No. of redialings
No. 3 4 5 6
0 0 0 0 : 16 times
0 0 0 1 : 1 times
0 0 1 0 : 2 times
0 0 1 1 : 3 times
1 1 1 1 : 15 times
7 Not used.
8 CRP option 0: Disable 1: Enable
 Selectors 1 through 6: Redial interval and No. of redialings
The machine redials by the number of times set by selectors 3 through 6 at intervals set by
selectors 1 and 2.
 Selector 8: CRP option
If a command error occurs in the machine (calling station), the machine usually waits for
three seconds and then makes a retry three times. This CRP option is a request command
that can be sent from the called station for requesting the calling station to retry the failed
command immediately.