Installation guide

Configuring Settings Using a Web Browser
105
3
❖
❖❖
❖ E-mail
• E-mail Address
Enter the e-mail address used as the destination.
• Register as Sender
Select whether to use the e-mail address not only as the destination but as
the sender also.
• Sender's Password
Select whether to set a password for the e-mail address.
When [On] is selected, a password is required when this e-mail address is
specified as the destination.
• Protected Password and Confirm Protected Password
Enter the password when [On] is selected for [Sender's Password], using four
to eight digits.
Each password digit appears as “*”.
Information to Register in [Search Destinations]
For easier and faster e-mail transmission, you can configure and register the E-
mail address search information.
Note
❒ After password authentication, you can configure [Search Destinations] menu
by: [Configuration]→[E-mail Settings]→[Search Destinations]
❖
❖❖
❖ LDAP Server IP Address
It configures the IP address of the LDAP search server. You can configure in
numeric characters from 0 to 9. If you do not use the LDAP search server, con-
figure at “000.000.000.000”. You can not configure at “225.225.225.225”, which
is unconfigurable.
❖
❖❖
❖ LDAP Server Port Number
It configures the port number to use when accessing the LDAP search server.
You can configure by entering the numeric from 1 to 65535; if an appropriate
number should be entered, the default value of 389 will be configured.
❖
❖❖
❖ Search Base (search start position)
It configures the search start position when searching the LDAP search serv-
er. You can enter the alphanumeric characters recognized by X.500 from 0 to
256 bytes.
❖
❖❖
❖ Max. Number of Search Results
It configures the maximum number of search to be done from the LDAP
search server. You can configure it within a range of 10 to 2000 in numeric
characters.
❖
❖❖
❖ Connection Wait Time
You can configure the time out duration by selecting [yes] with a radio button
click. Time out duration can be configured from 1 to 5 minutes.