Installation guide

Configuring the Scanner Settings

Note

❒ When you want to set no limitation of access to this machine, leave these

settings as their default values.

❒ When an IP address of a client computer falls within the logical products

of the access control entry and the access mask entry, the client computer

is granted its access to this machine.

❒ For example, a client computer that has an IP address within the range

shown under “Access-enabled IP address” column in the following table

has right to access this machine, in accordance with the entry of the access

mask to the left, when you set the access control to 192.168.15.18. In the fol-

lowing table, “xxx” means any value is available.

❖

❖❖

❖ Network Boot

Use this item to select whether you use this machine on a DHCP environment

or not. Set this item to “NONE” when a fixed IP address is assigned to this

machine on the network you use. Set this item to “DHCP” when you use this

machine on a DHCP environment.

Note

❒ If you plan to use delivery server function, assign an IP address of this ma-

chine statistically, even when you use this machine on a DHCP environ-

ment. You still have to select “DHCP” for [Network Boot], and do not enter

any value to the following setup items: [IP Address], [Subnet Mask], [Default

Gateway Address].

❒ After you have changed the setting of this item, turn off the power and

then back on to activate the change.

❖

❖❖

❖ DNS Server 1 IP Address (WSM)

Specify the IP address of the primary DNS server on the network you use this

machine, in the form of xxx.xxx.xxx.xxx (xxx:0 through 255).

Note

❒ This setting can only be configured using the Web Status Monitor.

Access mask entry Access-enabled IP address

000.000.000.000 xxx.xxx.xxx.xxx

255.255.000.000 192.168.xxx.xxx

255.255.240.000 192.168.0.xxx

∼192.168.15.xxx

255.255.255.000 192.168.15.xxx

255.255.255.240 192.168.15.16

∼192.168.15.31

255.255.255.255 192.168.15.18