User's Manual

Contains label
When a module is included in the end products and disappears from the outside at the time
of shipment, a Contains label is stuck on the end products.
A Contains label is the following contents.
About User manual
User manual and Installation manual will be supplied with this module.
(Note)
This module was granted as FCC/IC Limited Modular Approval. Host systems must provide regulated
supply voltages to the module. Separate evaluation must be required for any portable configuration.
When used in mobile applications, the antennas shown in this filing must be installed to provide a
separation distance of at least 20 cm from all persons.
OEM integrators and end-users must be provided with specific information required to satisfy RF
exposure compliance for the final host device.
OEM integrators are instructed to ensure that the end user has no manual instructions to remove or
install the device. The antenna of this device must not be co-located or used in conjunction with any
other antenna or transmitter. OEM integrators must be provided with antenna installation instructions.
Only those antennas tested with the device or similar antennas with equal or lesser gain may be used
with this transmitter.
This device complies with the Dynamic Frequency Selection (DFS) requirements of Report and Order FCC
03-287 as a Client only without Radar Detection.
Contains FCC ID: BBP-WLCMN01 Contain IC: 144D-WLCMN01
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.