User's Manual

ManualsBrandsRicoh ManualsElectronicsOptions(s) for Radiocommunications

1. Remove the slot cover [1] from the I/F Card Slot ( x 2).

2. Install the interface board (Knob-screw x 2) into the I/F card slot.

3. Make sure that the machine can recognize the option (see "Check All

Connections" at the end of this section).

IEEE 802.11a/g, g (Wireless LAN)

Installation Procedure

Unplug the main machine power cord before you do the following procedure.

You can only install one of the following network interfaces at one time: (IEEE

802.11a/g, g (Wireless LAN), IEEE1284, Bluetooth).

1. Remove the slot cover [1] from I/F Card Slot ( x 2).

1-17

Summary of content (5 pages)

PAGE 1
. Remove the slot cover [1] from the I/F Card Slot ( x 2). 2. Install the interface board (Knob-screw x 2) into the I/F card slot. 3. Make sure that the machine can recognize the option (see "Check All Connections" at the end of this section). IEEE 802.11a/g, g (Wireless LAN) Installation Procedure Unplug the main machine power cord before you do the following procedure. You can only install one of the following network interfaces at one time: (IEEE 802.11a/g, g (Wireless LAN), IEEE1284, Bluetooth). 1.
PAGE 2
. Install the wireless LAN board (Knob-screw x 2) into I/F card slot. 3. Install the wireless LAN card in the wireless LAN board. Make sure the card label faces the front of the machine. 4. Attach the cover to the wireless LAN card. 5. Make sure that the machine can recognize the option (see ‘Check All Connections’ at the end of this section). 6. Attach the transmission/reception antenna at the front left of the machine. 7. Attach the reception antenna at the rear right of the machine. 8.
PAGE 3
Fig 1. Location of “R-WL54MN, R-WL54CN” to be equipped for a printer (example) Fig 2.
PAGE 4
Note to users It is strictly forbidden to use antenna except designated. This equipment must not be co-located or operated in conjunction with any other antenna or transmitter This equipment complies with FCC radiation exposure limits set forth for uncontrolled equipment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65.
PAGE 5
Note to users in the United States of America Notice: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.