User's Manual

• Confirm that the Gigabit Ethernet board was correctly installed by printing the configuration page. If

it is correctly installed, "Gigabit Ethernet & USB 2.0" will appear for "Device Connection" on the

configuration page.

• If the board was not installed properly, repeat the procedure from step 2. If it cannot be installed

correctly even after reattempting installation, contact your sales or service representative.

• For details about printing the configuration page, see "Test Printing", Quick Installation Guide.

• Before using the Gigabit Ethernet board, you must configure settings from the printer control panel.

For details, see "Ethernet Configuration".

• p.59 "Ethernet Configuration"

Installing the Wireless LAN Interface Board

• Do not touch inside the controller board compartment. Doing so may cause a machine malfunction

or a burn.

• Before beginning work, ground yourself by touching something metal to discharge any static

electricity. Static electricity can damage the unit.

• Do not subject the unit to physical shocks.

1. Check the contents of the package.

BFL301S

2. Turn off the power, and then unplug the power cable.

2. Installing Options

R-WL54C1N/ R-WL54C1GN

Setting Manual to end product

PAGE 1
R-WL54C1N/ R-WL54C1GN Setting Manual to end product 2. Installing Options • Confirm that the Gigabit Ethernet board was correctly installed by printing the configuration page. If it is correctly installed, "Gigabit Ethernet & USB 2.0" will appear for "Device Connection" on the configuration page. 2 • If the board was not installed properly, repeat the procedure from step 2. If it cannot be installed correctly even after reattempting installation, contact your sales or service representative.
PAGE 2
Installing the Interface Units 3. Loosen the two screws and remove the cover of the Wireless LAN interface board installation unit. 2 BFL055S The removed cover is not used when installing the interface board. 4. Fully insert the Wireless LAN interface board. BFL058S 5. Tighten the two screws to secure the interface board. Check the Wireless LAN interface board is connected firmly to the controller board. • Confirm that the interface board was correctly installed by printing the configuration page.