Operating instructions

32DDO03.A
2 - 6
b. LOWER LIFT PLATFORM - Press and hold the UP/DOWN switch in the DOWN
position until the platform reaches ground level and the outer rollstop opens
completely.
c. Carefully place wheelchair centrally on platform, facing outward, and LOCK
WHEELCHAIR BRAKES. Be certain wheelchair is properly positioned on plat-
form and does not contact outer rollstop and prevent it from locking as the
platform rises.
d. RAISE LIFT PLATFORM - Press and hold the UP/DOWN switch in the UP po-
sition until the platform raises and stops automatically at the vehicle floor
level.
e. STOW LIFT PLATFORM OR RAMP/CLOSE DOORS - Press and hold the DE-
PLOY/STOW switch until the lift platform or ramp fully stows and the doors
close completely.
2. TO EXIT VEHICLE:
a. OPEN DOORS/DEPLOY LIFT PLATFORM OR RAMP - Press and hold control
pendant DEPLOY/STOW switch in the DEPLOY position until the doors open
and the lift platform fully deploys and stops automatically at the vehicle floor
level or the ramp fully deploys.
b. ALWAYS EXIT VEHICLE FACING OUTWARD. Be certain platform is safely at
vehicle floor level and platform rollstop is in an up and locked position.
c. LOWER LIFT PLATFORM - Press and hold the UP/DOWN switch in the DOWN
position until the platform reaches ground level and the outer rollstop opens
completely.
d. Release wheelchair brakes and carefully exit platform.
e. RAISE LIFT PLATFORM - Press and hold the UP/DOWN switch in the UP po-
sition until the platform raises and stops automatically at the vehicle floor
level.
STOW LIFT PLATFORM OR RAMP/CLOSE DOORS - Press and hold the DEPLOY/STOW
switch until the lift platform or ramp fully stows and the doors close completely.
3. MANUAL OPERATION
WARNING!
NEVER REMOVE THE EMERGENCY RELEASE PIN WHILE VEHICLE IS IN MOTION, AS
DOORS CAN OPEN CREAT ING A HAZARDOUS SITUATION FOR PASSENGERS. NEVER
ALLOW CHILDREN TO PLAY WITH THE RELEASE PIN.
— Remove the wing nut at the inboard end of the door operator motor unit.
— Tip the inboard end of the motor unit UPWARDS.
— Remove the Emergency Release Pin (cotter pin) from the connector rod.
— Slip the adjustable link off the connector rod.
— Push doors open clear of platform or ramp path.