Service manual

32DDO06.A

3. REAR-DOOR INSTALLATIONS

a. Attach angle bracket to the clevis bracket.

b. Refer to the kit installation instructions. Position and level angle/clevis bracket. Mark the

bracket holes to be drilled.

c. Using a 3/16" diameter drill bit, carefully drill holes into door post.

d. Refer to Figure 2-2. (Figure also applies to left-rear door installation except viewed in the oppo-

site direction. Bracket appearance may vary slightly for different vehicle manufacturers.) Install

and fasten the right and left bracket assemblies to the door posts.

e. Refer to the kit installation instructions. Cut and drill holes to the rear right door top and bottom

brackets as shown.

f. Position, align and tape template to the door panel, and mark all locations to be either cut-out or

drilled.

g. Refer to the kit installation instructions. Cut out slots in the door panel as shown.

h. Drill mounting holes into the inside door panel.

i. For right-rear door installation, remove the license plate box from the door.

NOTE: Use the supplied spacers to fill gaps between the top brackets and door operator main plates

when installing bolts.

FIGURE 2-2: RIGHT-REAR BRACKET ASSEMBLY INSTALLATION