Service manual

32DDO06.A

B. ELECTRICAL INSTALLATION

1. Refer to the kit installation instructions. Drill a 3/4" diameter hole in the door frame.

CAUTION!

Check vehicle before drilling. Do not drill into factory wiring, hydraulic lines, fuel lines, fuel tank, etc.

2. Drill a 3/4" diameter hole in the door jamb opposite the hole drilled in the door frame.

3. Deburr all drilled holes, installed the supplied grommet, and route the main harness assembly through the

grommet and into the vehicle.

4. For side-door installations, refer to the kit installation instructions and attach the helper-spring provided to

the end of the flex conduit and secure the other end inside the vehicle. This prevents the operator mecha-

nism from getting caught in the door jamb.

5. Refer to Figure 2-5. Plug the interconnecting electrical crossover cable between the power door operators

and the lift. Be certain to connect the end of the crossover cable with two cables (the short cable termi-

nates at the lift connector) to the left door operator, and the opposite end to the right door operator. If not

connected properly, the door sequencing will be reversed.

6. At vehicle engine compartment, connect the cable to the positive battery terminal.

FIGURE 2-5: POWER DOOR OPERATOR AND LIFT INTERCONNECT DIAGRAM