Service manual

32DDO06.A

8. Refer to Figure 2-7. Adjust the length of the hex-rod assembly as required until the left door closes tightly.

To adjust, loosen locknuts at ends of hex-rod, rotate the hex-rod, and then retighten the locknuts.

9. Remove actuator arms from the operators. Leave hex-rod assemblies attached at clevis bracket assem-

blies.

D. INSTALLATION COMPLETION

1. If power door operators are installed in side doors, reinstall stepwell cover.

2. Reinstall all door stops and latches, where applicable.

3. Reinstall plastic moisture barriers on doors.

4. Use door flange washer to cover the interior panel exit holes for the actuator arms. Reinstall door in-

terior panels, and then reinstall actuator arms on door operators.

5. Reinstall door trim, carpet, plywood, molding, wall paneling or any other material that was removed.

6. Refer to the Operating Instructions chapter of this manual and perform several cycles of operation.

FIGURE 2-7: HEX ROD ADJUSTMENT