Manual

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part # 11050500

58-64 Impala Black Series Front Shock Kit

For Use w/ CoolRide

Components:

2 20000011 Black Series shocks – eye/stud

1 90000483 Upper shock bracket

1 90000484 Upper shock bracket

2 90000471 Aluminum shock spacer

2 90001619 Shock stud

Hardware:

12 99373007 3/8” x 1” thread forming bolt Upper shock mounts

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.
PAGE 2
Installation Instructions 1. Position the upper shock mount on the frame so the hole in the bracket aligns with the hole in the side of the frame and the tab is against the bottom of the frame. You may have to trim some of the inner fender well for clearance. On manual shift cars you may have trim the bottom of the Z-bar clutch bracket on the driver’s side. 2. Mark the hole in the bottom of the frame and drill with 5/16” bit. Use the 3/8” self-tapping bolts supplied and bolt the bracket to the frame.
PAGE 3
When using factory lower arms: 3a. Drill a 1/2" hole in the lower control arm approximately 7 3/4" from the cross shaft bolt. Insert the shock stud through the lower shock eye and then place the aluminum spacer onto the stud. The step on the spacer will go into the arm. Slide the stud through the lower arm and secure w/ nut and washer. When using lower StrongArms: 3b. Insert the shock stud through the lower shock eye and then place the aluminum spacer onto the stud.