Instruction Manual

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part # 11161099

67-69 GM “F” Body & 68-74 GM “X” Body Front CoolRide Kit

Components:

2 90006781 Front air spring – 267c

1 90000531 Driver side lower air spring plate

1 90000532 Passenger side lower air spring plate

2 90000528 Upper air spring cup bracket

Hardware:

2 99371001 3/8” x 3/4" USS bolt Air spring to lower plate

2 99373005 3/8” lock washer Air spring to lower plate

8 99371004 3/8” x 1 1/4" USS bolt Air spring plate to lower arm

12 99372002 3/8” USS Nylok Air spring mounts

22 99373003 3/8” sae washer Air spring mounts

2 99435002 7/16” x 8” stud Cup bracket to frame

2 99433002 7/16” SAE flat washer Cup bracket to frame

2 99432001 7/16” USS Nylok nut Cup bracket to frame

2 99311004 5/16” x 5 1/2" USS bolt Sway bar end link

2 99312003 5/16” USS Nylok nut Sway bar end link

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.
PAGE 2
Installation Instructions ******Must be used w/ RideTech shock kit****** 1. To allow clearance for the air spring, aportion of the frame on the outside of the coil spring pocket must be removed. This is best done with a die grind & cutoff wheel or plasma cutter. Cut all corners round and grind all edges smooth. Note: It may be helpful to partially install the air spring assemble to see exactly what needs cut out. 2. The inner lip of the coil spring pocket must also be trimmed.
PAGE 3
. Place the lower air spring plate onto the lower control arm. The place is contoured to the arm and is self-locating. Make sure the back of the plate is square with the arm. Drill the holes one at a time while securing the plate with 3/8” x 1 1/4" bolts, Nylok nuts and two flat washers. Note: This is the driver’s side, the lower shock mount goes to the rear of the arm. 4. Apply thread sealant to the air fitting and screw it into the air spring.