Manual

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part # 11214099

82-02 Rear Camaro CoolRide Kit

Components:

2 90009000 Tapered sleeve air spring

1 90000416 Upper air spring bracket – Driver side

1 90000417 Upper air spring bracket – Passenger side

2 90000290 Lower rear air spring roll plate

Hardware:

4 99371001 3/8” x 3/4" USS bolt Air spring to upper bracket

4 99373005 3/8’ lock washer Air spring to upper bracket

6 99373003 3/8” SAE flat washer Air spring mounts

2 99371027 3/8” x 1” carriage bolt Upper bracket to car

2 99372002 3/8” USS Nylok nut Upper bracket to car

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.
PAGE 2
1. Raise and support vehicle at a safe and comfortable working height. 2. Support the axle then remove the shock absorber, coil spring, and upper coil spring rubber. Refer to service manual for proper disassembly procedure. It is easier to do one side at a time. You will have to pull the axle down to slip the coil spring out. *** Must Use Factory Length Shocks *** 3. Apply thread sealant to a 90 degree air fitting and screw it into the top of the air spring. 4.
PAGE 3
7. Reinstall the shock absorber. The stud of the shock will go through the upper air spring mount and will help hold it in place. 8. Place the lower air spring roll plate over the spring retainer on the axle. Note: The air spring will not be mechanically attached to the axle. Be sure to keep at least 20 psi in the rear springs at all time. 9. Check air spring clearance through full suspension travel. Allowing the air spring to rub will result in failure and is not a warrantable situation. 9.