Manual

7. Reinstall the shock absorber.
The stud of the shock will go
through the upper air spring mount
and will help hold it in place.
8. Place the lower air spring roll
plate over the spring retainer on the
axle.
Note: The air spring will not be
mechanically attached to the axle.
Be sure to keep at least 20 psi in the
rear springs at all time.
9. Check air spring clearance
through full suspension travel.
Allowing the air spring to rub will
result in failure and is not a
warrantable situation.
9. The factory bump stop must be
used to avoid damage to the air
spring. But to get maximum drop
from the kit it must be cut down to 1
½” tall.
10. Ride height on this air spring is
approximately 9” tall. Driving with
the car too low or too high may
cause damage to the air spring or
shocks absorbers.