Owner's manual

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part # 11226110

64-72 GM “A” Body Rear SA CoilOver Kit

For OEM Rear Differential

Shock Assembly:

2 24159999 5” stroke single adjustable shock

2 90002024 1.7” eye w/ rebound adjustment

4 90001994 .625” I.D. bearing

8 90001995 Bearing snap ring

Components:

2 59120225 Coil spring – 12” long / 225 # rate

2 90002222 Spring retainer kit

8 90002043 Aluminum spacer - .5” I.D.

4 70010828 Delrin Spring Washer

2 90002327 Upper shock bracket

1 90002224 Driver side lower ShockWave bracket

1 90002223 Passenger side lower ShockWave bracket

Hardware:

4 99311001 5/16”-18 x 1” Gr. 5 bolt Upper bracket to frame

4 99312001 5/16”-18 Nylok nut Upper bracket to frame

8 99313002 5/16” SAE flat washer Upper bracket to frame

2 99501027 1/2"-13 x 3 ¾” SAE bolt ShockWave bracket to trailing arm bracket

4 99501002 1/2"-13 x 1 ½” SAE bolt ShockWave bracket to factory shock bracket

4 99501003 1/2"-13 x 2 ½” SAE bolt ShockWave to upper and lower bracket

10 99502001 1/2"-13 SAE Nylok nut Lower ShockWave mount and mounting

10 99503001 1/2" SAE flat washer Lower ShockWave mount

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com Part # 11226110 64-72 GM “A” Body Rear SA CoilOver Kit For OEM Rear Differential Shock Assembly: 2 24159999 5” stroke single adjustable shock 2 90002024 1.7” eye w/ rebound adjustment 4 90001994 .625” I.D. bearing 8 90001995 Bearing snap ring Components: 2 59120225 Coil spring – 12” long / 225 # rate 2 90002222 Spring retainer kit 8 90002043 Aluminum spacer - .5” I.D.
PAGE 2
Installation Instructions 1. 2. 3. 4. Raise and safely support the vechile by the frame rails. Using a jack, slightly raise the axle approximately 1”. Remove the shock absorbers. Lower the axle down enough to remove the coil springs. The exhaust tail pipes may need to be removed and/or modified for ShockWave installation. 4. Remove the lower trailing arm mounting bolt. (Do one side at a time to keep the axle from rotating). 5.
PAGE 3
8. Fasten the new upper shock bracket into the factory shock location using the 5/16” x 1” bolts, flat washers and Nylok nuts supplied. Note: Position the bracket to offset the shock toward the center of the car. 9. Assemble the spring onto the Coilover. Assembly is explained on the next page. 10. Fasten the CoilOver to the upper bracket using a ½” x 2 ½” bolt and Nylok nut. ½” I.D. aluminum spacers must be installed on each side of the bearing. 11.
PAGE 4