User guide

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part # 11284099

65-70 Impala Rear CoolRide Kit

For Use w/ Stock Lower Arms

Components:

2 90006781 Air spring – double convoluted, 6.5” diameter, ¼” npt port

2 90000024 Upper cup bracket

2 90000224 Large upper washer (may not be needed)

2 90000070 Lower air spring roll plate

Hardware:

2 99435001 7/16” x 6” stud Cup bracket to frame

2 99432001 7/16” USS Nylok nut Cup bracket to frame

2 99433002 7/16” flat washer Cup bracket to frame

4 99372002 3/8” USS Nylok nut Air spring to cup bracket

2 99371001 3/8” x 3/4” USS bolt Air spring to axle

6 99373003 3/8” flat washer Air spring

2 99373005 3/8” lock washer Air spring to axle

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com Part # 11284099 65-70 Impala Rear CoolRide Kit For Use w/ Stock Lower Arms Components: 2 90006781 Air spring – double convoluted, 6.
PAGE 2
*****For use w/ RideTech shock kit***** 1. If you have a large hole in the coil spring retainer you will need to place the large upper washer on top of the frame to attach the upper cup bracket. 2. You will need to drill a hole in the upper coil spring pocket to route the airline through. Remove all burrs and use a grommet. 3. Apply thread sealant onto the air fitting and screw into the air spring. Place the upper cup bracket onto the air spring and secure with two 3/8” Nylok and flat washers.
PAGE 3
4. Place air spring assembly into the coil spring pocket with the stud protruding through the upper washer. The airline must be routed at this time. Secure with 7/16” nut and flat washer. 5. Slide the lower plate between the air spring and the lower arm. It is held tight with a 3/8” x 3/4" bolt with flat washer and lock washer. 6. This air spring should be approximately 5” tall at ride height.