Owner manual

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part # 11323699

78-88 GM “G” Body Upper StrongArms

Components:

1 90000429 Drivers side arm

1 90000430 Passenger side arm

2 90000899 Upper ball joint

2 90000436 Cross shaft

4 90001599 Inner bushing sleeve

4 90001090 Poly bushing half

4 99250001 ¼”-28 grease fitting – Use Lithium grease on frame bushings

Hardware:

4 99563001 9/16” USS flat washer Installed between bushing and shaft

4 99603003 5/8” USS flat washer Installed between nut and bushing

4 99622005 5/8” SAE crimp locking nuts Cross shaft to bushing

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.
PAGE 2
1. Fasten the upper arm to the frame using the factory hardware. Reinstall the current alignment shims, but vehicle must be realigned. 2. Drop ball joint down through upper arm. Slide ball joint boot over stud, then place boot retainer over the boot. Clamp assembly tight w/ the hardware supplied. 3. Fasten the ball joint to the spindle w/ the new castle nut and cotter pin supplied. 4. Tighten the cross shaft nuts enough to create drag on the poly bushings, the arm should still move.
PAGE 3
UCA5000 S-10 UPPER CONTROL ARM PASSENGER SIDE 9.313 3.375 NOTCH FACES OUTWARD TOP VIEW 8.
PAGE 4
Driver Side – Top View Item # 1. 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. Description Passenger side arm Driver side arm Cross shaft Cross shaft bushing Inner bushing sleeve 5/8” USS flat washer 9/16” USS flat washer 5/8”-18 lock nut Ball joint 1/4"-28 x 7/8” hex bolt 1/4"-28 nut Qty.