Owner's manual

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part # 11381499

99-06 Silverado Front Lower StrongArms

For Use w/ CoolRide

Components:

1 90000100 Driver side lower arm

1 90000101 Passenger side lower arm

2 90000901 Lower ball joint

2 90000198 3” inner bushing sleeve

2 90000199 3.5” inner bushing sleeve

8 90001085 Poly bushing half

2 90000921 90 degree 12mm PosiLink

2 90000922 Straight 12mm PosiLink

2 90000095 PosiLink T Bushing

2 90000096 PosiLink Spacer

4 99250001 ¼”-28 grease fitting – Use Lithium grease on frame bushings

Hardware Kit:

2 99122003 12mm x 1.75 x 60mm stud PosiLink (Use Loctite)

4 99122001 12mm x 1.5 Nylok nut PosiLink

6 99433002 7/16” SAE Gr.8 flat washer PosiLink

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com Part # 11381499 99-06 Silverado Front Lower StrongArms For Use w/ CoolRide Components: 1 90000100 Driver side lower arm 1 90000101 Passenger side lower arm 2 90000901 Lower ball joint 2 90000198 3” inner bushing sleeve 2 90000199 3.
PAGE 2
Installation Instructions 1. After removing the factory lower control arm, clean the bushing mounting surfaces on the frame and lubricate with the lithium grease supplied. 2. Fasten the lower arm to the frame using the factory hardware. 3. Slide the ball joint boot over the stud, then push the stud down through the spindle. Secure w/ the new castle nut and cotter pin supplied. 4. Attach to the air spring & shock to the lower arm using the hardware supplied w/ those kits. 5.
PAGE 3
99-06 Silverado CoolRide Driver Side StrongArm Item # 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. Description Driver side arm Ball joint Inner bushing sleeve – 3” Inner bushing sleeve – 3.5” Poly bushing half 90 degree 12mm PosiLink Straight 12mm PosiLink PosiLink T Bushing PosiLink Spacer 12mm x 1.75 x 60mm stud Grease fitting 7/16” SAE Gr.8 flat washer 12mm x 1.5 Nylok nut Qty.