Manual

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part # 12060999

61-69 Lincoln Front CoolRide

For Use w/ Lower StrongArms

Components:

2 90006873 224c Air spring

2 90000694 Upper air spring mount

2 90000683 Upper mounting plate

2 90000682 Upper mounting plate spacer

1 90000684 Driver side brake line tab

1 90000685 Passenger side brake line tab

Hardware:

4 99371006 3/8” x 1 ½” USS bolt Upper plate

2 99371005 3/8” x 1 ¼” USS bolt Upper plate

12 99373003 3/8” SAE flat washer Upper plate & air spring

8 99373005 3/8” lock washer Upper plate & air spring

4 99372004 3/8” USS nut Upper plate

2 99435002 7/16” x 8” stud Upper air spring mount (Cut off to 6 ¾” long)

2 99433002 7/16” SAE flat washer Upper air spring mount

2 99432001 7/16” USS Nylok nut Upper air spring mount

4 99372002 3/8” USS Nylok nut Air spring to upper mount

2 99371001 3/8” x 3/4” USS bolt Air spring to lower arm

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.
PAGE 2
Installation Instructions for ARF10900-LCA 1. Raise the vehicle to a safe and comfortable working height. Support the vehicle by the frame so that the suspension can hang freely. 2. Remove the coil spring, lower control arm and shock absorber. Refer to factory service manual for disassembly procedures. 3. The inner fender well shield next to the upper control arm and the factory brake line frame bracket must also be removed. 4. Remove the factory upper shock mount.
PAGE 3
6. Thread the 7/16” x 6 ¾” stud into the nut in the bottom of the bracket. 7. Raise the assembly into the coil spring pocket with the stud protruding through the upper plate. The wings on the side of the bracket will rest against the flat side of the coil spring retainer. 8. Secure the assembly with a 7/16” Nylok nut and flat washer. Note: The air line must also be routed at this time. 9. Bolt the lower StongArm to the frame using the 3/4" x 8” bolt and the two spacers supplied.