User guide

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax 812.634.6632

www.ridetech.com

Part # 12102899

67-70 Mustang Lower StrongArms

Components:

1 90000110 Driver side lower arm

1 90000111 Passengers side lower arm

2 90000895 Lower ball joint

4 90000112 Eccentric eliminator

2 90000108 Inner bushing sleeve

4 90001086 Poly bushing half

2 90001045 Control arm pivot bearing

2 90000734 Bearing housing

2 90000109 Bearing retaining plate

2 90000733 Aluminum bearing spacer

2 90000732 Bearing stud (Set to 2- 15/16”)

2 99250001 1/4-28 grease fitting – Use Lithium grease on frame bushings

Hardware:

2 99501025 ½”-13 x 4 ½” Gr.5 bolt Lower arm to frame

2 99502001 ½”-13 Nylok nut Lower arm to frame

6 99371019 3/8”-16 x 1 ½ SHCS Bearing housing

6 99373005 3/8” lock washer Bearing housing

2 99752004 ¾”-16 Jam nut Stud to arm

2 99752001 ¾”-16 Lock nut Stud to bearing

2 99753002 ¾” x 2” flat washer Stud to bearing

PAGE 1
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.
PAGE 2
Installation Instructions 1. Raise and support vehicle at a safe, comfortable working height. Let the front suspension hang freely. 2. Remove the coil spring, shock absorber, upper shock bracket, strut rod, sway bar, upper and lower control arms. Refer to factory service manual for proper disassembly procedure. 3. Be sure to remove the outer bushing sleeve from the strut rod frame mount. 4. Remove any excess undercoating or rust. 5.
PAGE 3
8. The bearing stud should already be threaded into the lower arm, factory set at 2-15/16” (measuring from the end of the arm to the bearing). 9. Slide the stud through the bearing, then slide the aluminum spacer over the stud with the larger end toward the front of the car. Secure the assembly with a ¾” Nylok Nut and flat washer. Note: The caster setting should set at around 3.5 degrees positive. Vehicle must be aligned before driving. 10.
PAGE 4
Item # 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. Description Driver side arm Eccentric eliminator plate Inner bushing sleeve Poly bushing half Bearing housing Bearing retaining plate Aluminum bearing spacer Bearing stud (Set to 2- 15/16”) Ball Joint Control arm pivot bearing ¾”-16 Jam nut ¾”-16 Lock nut ¾” x 2” flat washer ½”-13 x 4 ½” Gr.5 bolt ½”-13 Nylok nut 3/8” lock washer 3/8”-16 x 1 ½ SHCS Qty.