Full Product Manual

999-995-220.10_REV. B
6
RP 350/RP 351 Press Tools
Light Segment Number
(Light Continuously On)
Description
————Press tool off (OFF).
Green Green Green Green ON button pressed, lights on 4 seconds at start up, tool in “Normal
Mode”.
Blue Blue Blue Blue
ON button pressed, lights on 4 seconds at start up, tool in "Control
Mode" - see Bluetooth Functions section to change mode.
Green ———Press tool is in Normal Mode, standby, press tool ready to operate.
Red Yellow Yellow Yellow
Tool has malfunctioned. Tool will not operate. Remove and reinsert
battery or AC Adapter. If light still on, have tool serviced.
Red ———
Tool has malfunctioned. Tool will not operate. Remove and reinsert
battery or AC Adapter. If red light still on, have tool serviced.
Yellow — Red Red
Tool and/or battery out of Specification temperature range. Tool will
not operate. Bring the tool and battery to correct operating temper-
ature range.
Yellow ——Red
Attachment mounting pin is not fully inserted. Tool will not operate.
Fully insert pin. If lights still on, have tool serviced.
Yellow Red ——
Battery low. Tool will not operate. Recharge battery/Insert fully
charged battery.
Green Blue Blue Blue
Bluetooth connection established, standby, press tool ready to
operate - For further information see section on Bluetooth
Functions.
Purple Firmware update in process, tool cannot be used while updating.
Figure 5 – Tool Status Lights
Control Marking Description
Main tool power switch. (I = ON, O = OFF).
On/Off Button
ON: Press button until light turns ON. See Figure 5 – Tool Status Lights.
OFF: Press button until light turns OFF. Tool will automatically turn OFF if left unused for ten
(10) minutes.
Run Switch —
Turn On Work Light: slightly depress run switch.
Normal Mode: Depress run switch to start press cycle, release when tool locks on. Normal
mode is factory setting.
Control Mode: Depress run switch to engage attachment on workpiece. Make adjustments
as necessary. Press the run switch again to start press cycle, release when tool locks on.
Releasing the switch will not stop the tool once it has locked on. This assures consistent,
repeatable press connection integrity.
Mode can be changed with RIDGID Link App, see Bluetooth Functions section.
Pressure Allows tool to be released without completing press. If used, press connection is not complete
Release Button and must be repeated.
Attachment
— Holds attachment to tool. Must be fully inserted for tool to operate. See Figure 6.
Mounting Pin
Figure 4 – Controls Chart
1
3
4
2
1
2 4
3