User Guide

Ridge Tool Company
5
SeeSnake
®
microReel Inspection System
Figure 1 – Front View (SeeSnake Configuration)
microReel System Components
System Cable for
SeeSnake CCU
Camera Head
Shoulder Strap
Camera Clip
Case Latch
Pushrod
Guide
Feet
Front Case
Figure 2 – Rear View (microEXPLORER Camera Monitor
Configuration)
Assembly
WARNING
To reduce the risk of serious injury during use, follow
these procedures for proper assembly.
Camera Head Routing
1. Set the unit on a level surface laying it on its side.
2. Unfasten the case latches on either side of the
microReel (Figure 4) .
Figure 4 – Unlatching the microReel Case
3. Open the case carefully and only far enough to slip
the camera out through the cable guide. When rout-
ing the camera head out through the cable guide be
careful to avoid letting the pushcable spring out of
the drum or uncoil freely. Close the case and secure
the camera head in the provided clip.
microEXPLORER
Camera Monitor
Slip Ring Module
System Cable for
MicroEXPLORER
Camera Monitor
Case Latch
Feet
Rear Case
microEXPLORER
Camera Monitor
Connector Plug
microEXPLORER
Camera Monitor
Cradle
Cord Wrap
Figure 3 – Opening The Case
Camera
Head
Removable
Pushrod Drum
Pushrod
CountPlus
Keypad