Brochure

FIND THE RIGHT CHAIN KNOCKER FOR
THE JOB TO GET WALL-TO-WALL CLEAN
Use the table below for recommended options based on blockage, pipe size and pipe type.
K9-102 MACHINEK9-204 MACHINE
THE RIGHT TOOL FOR THE JOB
FlexShaft machines require a cordless drill equipped with an
adjustable clutch and a speed range between 1800 and 2500
RPM. Do not use with an impact driver or corded drill.
1
MODE MATTERS
Always set your drill to screw driving mode to enable the
adjustable clutch. The clutch is not operational in drill or
hammer modes (common markings are shown).
3
DIAL UP THE SPEED
Set your drill to the highest speed – typically setting “2” or
“3” is optimal.
2
MANAGE YOUR CLUTCH
Always start cleaning with the adjustable clutch set
relatively low (~25% of the max range).
4
A QUICK GUIDE FOR PROPER DRILL SETUP AND CLEANING
Read and follow all warnings and instructions for all equipment and materials used with these machines.
1
3
DRILL MODE –
Clutch Not Operational
SCREW DRIVING MODE –
Clutch Operational
H
AMMER MODE –
Clutch Not Operational
2 4
40
DESCRIPTION
K9-102 1½" K9-102 2"
K9-102
1½" CARBIDE
K9-102
2" CARBIDE
K9-102 - 1½"
PENETRATING
HEAD
K9-102 - 2"
PENETRATING
HEAD
K9-204 2" K9-204 3" K9-204 4"
K9-204
2" CARBIDE
K9-204
3" CARBIDE
K9-204
4" CARBIDE
K9-204 - 2"
PENETRATING
HEAD
K9-204 - 3"
PENETRATING
HEAD
K9-204 - 4"
PENETRATING
HEAD
CATALOG NO.
64293 64298 64283 64288 66568 66573 64323 64328 64333 64308 64313 64318 66578 66583 66588
PIPE SIZE
1¼"-1½"
(32-40 mm)
2"
(50 mm)
1¼"-1½"
(32-40 mm)
2"
(50 mm)
1¼"-1½"
(32-40 mm)
2"
(50 mm)
2"
(50 mm)
3"
(75 mm)
4"
(100 mm)
2"
(50 mm)
3"
(75 mm)
4"
(100 mm)
2"
(50 mm)
3"
(75 mm)
4"
(100 mm)
COPPER
GALVANIZED
CAST IRON
PVC
ABS
ORANGEBURG
CORRUGATED
CLAY
GREASE
SOFT
BLOCKAGE
SCALING
LIGHT ROOTS
WIPES
INCLUDED
WITH KIT
BLOCKAGE PIPE TYPE
K9-102 MACHINE
K9-204 MACHINE
Carbide Tipped
Chain Knockers
Chain Knockers
Penetrating Head
Chain Knockers
Chain Knockers Carbide Tipped Chain Knockers
Penetrating Head
Chain Knockers
K9-102 & K9-204