Instructions / Assembly

ManualsBrandsRIDGID ManualsInspection CamerasMicro Hand-Held Video Inspection Camera

Figure 7 – Cable Connections

3' (90 cm) and 6' (180 cm) cable extensions are

available to increase the length of your camera

cable up to 30 feet (9 m). To install an extension,

first remove the camera head cable from the

display unit by loosening the knurled knob.

Connect the extension to the handheld as de-

scribed above (Figure 7). Connect the keyed

end of the camera head cable to the slotted end

of the extension and finger tighten the knurled

knob to hold the connection in place.

Installing Accessories

The three included accessories, (Hook, Mag -

net, Mirror) all attach to the imager head the

same way.

Figure 8 – Installing an Accessory

To connect, hold the imager head as shown in

Figure 8. Slip the semicircle end of the acces-

sory over the flats of the imager head. Then ro-

tate the accessory a 1/4 turn to retain.

Installing SD™ Card

Open the left side port cover (Figure 4) to ac-

cess the SD card slot. Insert the SD card into

the slot making sure the contacts are facing to-

wards you and the angled portion of the card is

facing down (Figure 9). SD cards can only be

installed one way – do not force. When an SD

card is installed, a small SD card icon will ap-

pear in the upper left hand portion of the

screen, along with the number of images or

length of video that can be stored on the SD

card.

Changing/Installing Batteries

The micro CA-350 is supplied without the bat-

tery installed. If the battery indicator displays

, the battery needs to be recharged. Re -

move the battery prior to storage.

1. Squeeze the battery tabs (See Figure 5)

and pull to remove battery.

Figure 5 – Removing/Installing Battery

2. Insert contact end of battery into the in-

spection tool, as shown in Figure 5.

Powering with the AC Adapter

The micro CA-350 Inspection Camera can al -

so be powered using the supplied AC Adapter.

1. Open the right side port cover (Figure 3).

2. With dry hands, plug the AC adapter into

the outlet.

3. Insert the AC adapter barrel plug into the

port marked “DC 12V”.

Figure 6 – Powering the Unit with AC Adapter

Installing the Imager Head

Cable or Extension Cables

To use the micro CA-350 Inspection Cam er a,

the imager head cable must be connected to

the handheld display unit. To connect the

cable to the handheld display unit, make sure

the camera socket key and display unit socket

slot (Figure 7) are properly aligned. Once they

are aligned, finger tighten the knurled knob to

hold the connection in place.

micro CA-350 Inspection Camera

Accessory

1/4 Turn

Flats

Summary of content (3 pages)

PAGE 1
micro CA-350 Inspection Camera Changing/Installing Batteries The micro CA-350 is supplied without the battery installed. If the battery indicator displays , the battery needs to be recharged. Remove the battery prior to storage. 1. Squeeze the battery tabs (See Figure 5) and pull to remove battery. Figure 7 – Cable Connections 3' (90 cm) and 6' (180 cm) cable extensions are available to increase the length of your camera cable up to 30 feet (9 m).
PAGE 2
micro CA-350 Inspection Camera 7. Check to make sure the connections between the handheld unit, extension cables and imager cable are tight. All connections must be properly assembled for the cable to be water resistant. Confirm unit is properly assembled. 8. Check that the warning label is present, firmly attached and readable (Figure 10). Figure 9 – Inserting the SD Card Pre-Operation Inspection WARNING Figure 10 – Warning Label 9.
PAGE 3