micro CA-350 Inspection Camera Figure 11 – Splash Screen (Note: Version will change with each firmware update.) Figure 13 – Screen Shot of Mode Selection Live Screen The live screen is where you will do most of your work. A live image of what the camera sees is displayed on the screen. You can zoom, adjust LED brightness and take images or video from this screen. The screen has a status bar at the top showing the tool mode, zoom, SD™ card icon if inserted, available memory and speaker/mic ON/OFF.
micro CA-350 Inspection Camera the video mode icon and the recording duration will show at the top of the screen. Press the shutter button again to stop the video. It may take several seconds to save the video if saving to the internal memory. The micro CA-350 features an integrated microphone and speaker for recording and playback of audio with video. A headset with integrated microphone is included and may be used instead of the integrated speaker and microphone.
micro CA-350 Inspection Camera TV-Out Select the “NTSC” or “PAL” to enable the TVOut for the video format required. Screen will go black and image will be transmitted to external screen. To get live image on unit, hit Power button to disable function. Update Firmware Figure 17 – Settings Screen Playback Mode 1. Pressing the Select button in the live screen will enter playback mode. Select either Image or Video to playback the desired file. The playback mode is the interface into saved files.
micro CA-350 Inspection Camera Connecting to TV The micro CA-350 Inspection Camera can be connected to a television or other monitor for remote viewing or recording through the included RCA cable. Open the right side port cover (Figure 3). Insert the RCA cable into the TV-Out jack. Insert the other end of the cable into the VideoIn jack on the television or monitor. Check to make sure the video format (NTSC or PAL) output is set properly.
micro CA-350 Inspection Camera Maintenance WARNING Remove battery before cleaning. • Always clean the imager head and cable after use with mild soap or mild detergent. • Gently clean the display screen with a clean dry cloth. Avoid rubbing too hard. • Use only alcohol swabs to clean the cable connections. • Wipe the hand held display unit down with a clean, dry cloth. Reset Function If the unit stops functioning and does not operate, press the Reset Button (under the left side port cover – Figure 4).
micro CA-350 Inspection Camera • Contact your local RIDGID distributor. • Visit RIDGID.com to find your local RIDGID contact point. • Contact Ridge Tool Technical Service Department at rtctechservices@emerson.com, or in the U.S. and Canada call (800) 5193456. Disposal Parts of the RIDGID micro CA-350 Inspection Camera contain valuable materials and can be recycled. There are companies that specialize in recycling that may be found locally.