Use and Care Manual

FT6013 - MITER TRIM CUTTER BLADE
For use with RIDGID FT6012 Miter Trim Cutter only.
REPLACING THE BLADE
See Figures 1 and 2.
WARNING:
Blades are sharp. Use extreme caution and wear heavy-
duty gloves when replacing the blade. Failure to heed this
warning can result in serious personal injury.
 Hold the handles together and rotate the locking lever to lock the
cutter.
 Remove the bolt and nut securing the lower handle to the upper
handle.
 Rotate the locking lever to unlock the cutter.
 Slide the lower handle away from the upper handle.
 Remove the bushing and old blade from the lower handle.
 Slide the new blade into the lower handle until the tab in the
handle engages the notch in the blade. Make sure that the holes
are aligned, then secure with bushing.
 Insert lower handle into upper handle with the cutting edge of the
blade facing the cutting table.
 Align the holes in the handles and blade.
 Insert bolt through holes and secure using nut. Tighten securely.
NOTE: The bolt has a square shoulder. Ensure it is fully seated in
the square hole before tightening nut.
A - Nut (écrou, tuerca)
B - Bolt (boulon, perno)
C - Square hole (trou carré,
agujero cuadrada)
D - Locking lever (levier de
verrouillage, palanca de fijación)
A - Upper handle (poignée supérieure,
mango superior)
B - Blade (lame, hoja)
C - Bushing (douille, buje)
D - Lower handle (poignée inférieure,
mango inferior)
D
C
A
B
A
B
D
C
Fig. 1
Fig. 2
ONE WORLD TECHNOLOGIES, INC.
P.O. Box 1427, Anderson, SC 29622 / 1-866-539-1710 / www.ridgid.com
RIDGID is a registered trademark of RIDGID, Inc., used under license.