Full Product Manual

5
WET/DRY VAC ASSEMBLY (Fig. 4)
1. To Attach the Powerhead Assembly to Dust Drum:
Place Powerhead Assembly (A) on top of Dust Drum
(B) with the Extended Lip of the Lid aligned with the Vac
Inlet Port. Be sure Powerhead Assembly is fully seated
on the Dust Drum.
2. Press in on the Two Latches, located on either side of
the Dust Drum (B) until they snap into place, securing
the Powerhead Assembly to the Dust Drum.
3. To Remove the Powerhead Assembly: Pull out on the
Two Latches and lift Powerhead Assembly from the
Dust Drum. Do not force the Latches to rotate more
than slightly outside Drum flange.
(A)
(B)
Vac
Inlet
Port
Drum
Latch (2)
Extended
Lip
Vac Inlet Port
Hose Locking
Tab
(H)
CARRY HANDLE/POWER CORD WRAP
ASSEMBLY (Fig. 5)
1. Locate the Carry Handle/Power Cord Wrap (C) and
the Two #10 x 3/4” (19 mm) Pan Head Screws in loose
parts bag.
2. Position the Carry Handle/Power Cord Wrap (C) on
top of the Powerhead Assembly (A), with the Carry
Handle/Power Cord Wrap Extended Flange to the rear
of the Powerhead Assembly, as shown.
3. Insert a #10 x 3/4” (19 mm) Pan Head Screw (D)
through the Hole at each end of the Carry Handle/
Power Cord Wrap and into the Powerhead Assembly.
Tighten securely.
(D)
(C)
(A)
ATTACHING AND REMOVING VACUUM HOSE
(Fig. 6)
1. To Insert Hose: Locate the larger end of the Tug-
A-Long Positive Locking Hose with Dual-Flex (H)
Push the Hose into the Vac Inlet Port. Engage the
Hose Locking Tab onto the lip of the Vac Inlet Port.
The Hose should snap into place.
2. To Remove Hose: Press the Tug-A-Long Positive
Locking Hose with Dual-Flex Locking Tab and pull
the Hose end straight out of the Vac Inlet Port.
ASSEMBLY
Fig. 4
Fig. 5
Fig. 6