Use and Care Manual

6
ASSEMBLY
NOTE: Remove Powerhead Assembly
from Dust Drum prior to assembly of
Casters and Caster Feet.
1. Turn Dust Drum upside down on floor.
2. Place Caster Foot on floor. Insert the
stem of a Caster into socket of Caster
Foot.
3. Push on the Caster until the Caster ball
end snaps fully into the Socket and the
Caster swivel freely. Repeat for other
three Casters and Caster Feet.
4. Place Caster Foot with Caster over
post on bottom of Dust Drum and press
firmly in place, as shown.
5. Repeat for the other three Caster/
Caster Foot assemblies.
6. Four Screws are available for optional
assembly of the Caster Feet into
the Drum. If desired, locate Four (4)
#10 x 3/4” (19 mm) Pan Head Screws
in loose parts bag. Insert a Screw
through the Hole in the Caster Foot and
into the Dust Drum. Tighten securely.
7. Turn the Dust Drum upright.
Caster/Caster Foot Assembly
Caster
Foot
Caster
Caster Ball
Caster Stem
Optional Hole
for Screw
Placement
Caster Foot
Post Hole
Caster Foot
Post
Dust
Drum
Wet/Dry Vac Assembly:
Locking
Tabs (2)
Accessory
Caddy
Dust Drum
ASSEMBLED
Accessory Caddy Installation
1. Position the Accessory Caddy on the
back of the Dust Drum and align the
Locking Tabs.
2. Slide the Accessory Caddy Tabs into
the Dust Drum and push the Locking
Tabs in until you hear a click. Pull on
the Accessory Caddy to confirm it has
locked into place.
SP7050-1 ESF.indb 6 9/3/19 10:16 AM