User Manual

micro CL-100 Self-Leveling Cross Line Laser
6
Laser
Window
ON/OFF
Switch
Gradient Base
Figure 2 - Laser Parts
5
/
8
- 11 Thread
for Mounting
Icons
LOCK
UNLOCK
Laser Classification
The RIDGID micro CL-100 Self- Leveling
Cross Line Laser generates visible laser
beams that are emitted from the front of the de-
vice.
The device complies with class 2 lasers ac-
cording to: EN 60825-1:1994/A11:1995/-
A2:2001/A1:2002
Electromagnetic
Compatibility (EMC)
The term electromagnetic compatibility is
taken to mean the capability of the prod-
uct to function smoothly in an environment
where electromagnetic radiation and elec-
trostatic discharges are present and without
causing electromagnet interference to other
equipment.
NO TICE
The RIDGID micro CL-100 Self-Leveling
Cross Line Laser conforms to all applicable EMC
standards. However, the possibility of them
causing interference in other devices cannot be
precluded.
Changing/Installing
Batteries
The RIDGID micro CL-100 Self-Leveling Cross
Line Laser is supplied without batteries in-
stalled. Remove the batteries prior to long
term storage to avoid battery leakage.
1. Make sure the laser is OFF (ON/OFF switch
turned fully counter clockwise).
2. Remove the battery cover by depressing
the tab (Figure 3). If present, remove the
white sensormatic tag from the battery
compartment. Remove the batteries if
needed.
3. Install three AAA (LR03) batteries into
battery holder, observing the correct
polarity as indicated in the battery com-
partment.
NO TICE
Use batteries that are of the same
type. Do not mix battery types. Do not mix
new and used batteries. Mixing batteries can
cause overheating and battery damage.
4. Securely replace the battery cover.
Pre‑Operation Inspection
WARNING
Before each use, inspect your laser and cor‑
rect any problems to reduce the risk of in‑
jury and prevent tool damage.
Do not look into the laser beam. Looking
into the laser beam may be hazardous to
the eyes.
1. Make sure the unit is OFF and the sel-
eveling mechanism locked (ON/OFF
switch turned fully counterclockwise).
2. Remove the batteries and inspect for
signs of damage. Replace batteries if
necessary. Do not use equipment if the
batteries are damaged.
3. Clean any oil, grease or dirt from the
equipment. This aids inspection and
helps prevent the tool from slipping
from your grip.
4. Inspect the laser for any broken, worn,
missing or binding parts or any condi-
tion which may prevent safe and normal
operation.
5. Check that the warning labels are pres-
ent, rmly attached and readable.