Operator's Manual

22
INDICATOR
SCREW
SCALE
INDICA
TOR
MITER
SCALE
®
®
®
ASSEMBLY
VIEW OF BLADE NOT SQUARE WITH FENCE,
ADJUSTMENTS ARE REQUIRED
Fig. 23
SLIDING
MITER
FENCE
FRAMING
SQUARE
MITER
T
ABLE
BLADE
 Rotate the miter table until the pointer on the miter scale
is positioned at 0
°
.
 Lock the miter lock lever by pushing it down.
 Remove the sliding miter fence by loosening the fence
scr
ew and lifting the sliding miter fence off the saw.
 Lay a framing square flat on the miter table. Place one
leg
of the square against the fence. Slide the other leg
of the square against the flat part of saw blade.
NOTE: Make sure that the square contacts the flat part
of the saw blade, not the blade teeth.
 The edge of the square and the saw blade should be
parallel as shown in figur
e 20.
 If the front or back edge of the saw blade angles away
fr
om the square as shown in figures 21 and 22, adjust-
ments are needed.
 Loosen the socket head screws that secure the fence to
the miter table. See Figure 19.
 Rotate the fence left or right until the saw blade is parallel
with the squar
e.
 Retighten the socket head screws securely and recheck
the blade-to-fence alignment.
Y
our saw has several scale indicators. After squaring adjust-
ments
have been made, it may be necessary to loosen the
indicator screws and reset them to zero. See Figure 23.
VIEW OF BLADE NOT SQUARE WITH FENCE,
ADJUSTMENTS ARE REQUIRED
SLIDING
MITER
FENCE
MITER
T
ABLE
FRAMING
SQUARE
BLADE
Fig. 21
®
Fig. 20
VIEW OF BLADE SQUARE WITH FENCE
SLIDING
MITER
FENCE
BLADE
MITER
LOCK
LEVER
FRAMING
SQUARE
MITER
T
ABLE
Fig. 22