Use and Care Manual

11 - English
OPERATION
WARNING:
During normal use the tool will recoil immediately
after driving a fastener. This is a normal function
of the tool. Do not attempt to prevent the recoil
by holding the nailer against the work. Restriction
to the recoil can result in a second fastener being
driven from the nailer. Grip the handle firmly, let the
tool do the work, and do not place second hand on
top of tool at any time. Failure to heed this warning
can result in serious personal injury.
DRIVE DEPTH ADJUSTMENT
See Figure 9, page 15.
The driving depth of the nail may be adjusted by rotating the
dial clockwise to increase or counterclockwise to decrease
the depth the nail is driven. It is advisable to test the depth
on a scrap workpiece to determine the required depth for
the application and to drive a test nail after each adjustment
until the desired depth is set.
REMOVING NAILS FROM THE TOOL
See Figure 10, page 15.
 Remove the battery pack from the tool.
WARNING:
Remove the battery pack from the tool before
removing nails. Failure to do so could result in
serious personal injury.
 To remove a strip of nails from the tool, hold the finish
nailer by the handle with your right hand, and rest your
left hand underneath the tool with your left thumb on the
pusher.
 Depress the inside lever on the pusher to release and
allow the pusher to slowly slide to the front.
NOTE: Always keep fingers clear of nail track of magazine
to prevent injury from unintended release of the pusher.
 Slide the nails toward the back of the magazine and
remove.
CLEARING A JAMMED FASTENER
See Figure 11, page 15.
WARNING:
Remove the battery pack from the tool before
clearing a jammed fastener. Failure to do so could
result in serious personal injury.
If a nail or fastener becomes jammed in the tool, remove
the battery pack and keep the tool pointed away from you
while clearing the jam.
 Remove the battery pack from the tool.
 Remove fasteners from the tool.
 Pull up on the latch and open the jam release.
 Insert a flat blade screwdriver into the driving mechanism
and push the driver mechanism back, freeing the fastener
jam.
 Remove the bent fastener.
 Close the jam release and latch.
 Reinstall the battery pack.
 Reinstall fasteners and close the magazine.