Use and Care Manual

23
CUTTING WARPED MATERIAL
See Figure 25.
When attempting to cut warped material, the CONVEX face
should be against the fence.
See Figure 26.
NEVER position a piece of warped material with the CONCAVE
face or edge against the fence. It will pinch the blade near the
completion of the cut.
To avoid a kickback and to avoid serious
personal injury, NEVER position the concave edge of bowed or
warped material against the fence.
OPERATION
Figure 25
Figure 26
CLAMPING WIDE WORKPIECES
Figure 27
When cutting wide work pieces, such as 2 X 12 inch, clamp the
workpiece to the work table using a work clamp
F10
as shown
in Figure 27.
KEEP clamps away from the path of the
blade and blade guard assembly.
F10