Use and Care Manual

31
OPERATION
Figure 39
Figure 40
Figure 41
X
X
EXPAND WORKTABLE AREA
This saw is designed to allow for large capacity cuts up to
2 x 12 inch. In order to make these cuts you will need to
configure your saw appropriately.
DO NOT use an auxiliary table board which
will not fully support the workpiece during cutting operation.
1. Loosen the fence lock knob
A
. Slide the upper fences
B
completely out of their tracks and set them to the
side. See Figure 39.
2. Flip the back fence support tabs
F
into position. The
Tabs
F
are on both the left and right sides of the
lower (fixed) fence. These will function as your
workpiece backstop. See Figure 40.
3. You will need to add a 2 x 12 auxiliary table board
C
to support your large capacity workpiece
D
. See
Figure 41.
NOTE: The Auxiliary Table Board should be as wide as the
lower (xed) fence and secured to the lower fence using
wood screws, see Figure 41.
4. The large capacity workpiece is supported against the
step in the xed fence
E
Figure 41.
TIGHTEN
LOOSEN
B
A
D
E
C
F