Use and Care Manual

ManualsBrandsRIDGID ManualsPower Tool Combo Kits18-Volt Cordless 10-Piece Combo Kit with (1) 4.0 Ah Battery and (1) 2.0 Ah Battery, Charger, and Bag

5 - English

FEATURES

PRODUCT SPECIFICATIONS

No Load Speed ...........................................................................................................................0-550/0-2,100 r/min. (RPM)

Impact Speed ...................................................................................................................................... 0-7,150/0-27,300 IPM

UNPACKING

This product requires assembly.

 Carefully remove the tool and any accessories from the

box. All items listed in the Includes section must be

included at the time of purchase.

WARNING:

Items in this Assembly section are not assembled

to the product by the manufacturer and require

customer installation. Use of a product that may

have been improperly assembled could result in

serious personal injury.

 If any parts are damaged or missing, please call

1-866-539-1710 for assistance.

WARNING:

If any parts are damaged or missing do not operate

this product until the parts are replaced. Use of

this product with damaged or missing parts could

result in serious personal injury.

WARNING:

Do not attempt to modify this product or create

accessories or attachments not recommended

for use with this product. Any such alteration

or modification is misuse and could result in a

hazardous condition leading to possible serious

personal injury.

ASSEMBLY

INSTALLING/REMOVING THE AUXILIARY

HANDLE ASSEMBLY

See Figures 1 - 2, page 11.

An auxiliary handle is included for ease of operation and to

help prevent loss of control. The handle can be mounted for

left or right hand use.

To install the auxiliary handle assembly:

 Remove the battery pack.

 Turn the handle grip counterclockwise to loosen it and

open the hooks wide enough to fit over the mounting ribs,

behind the torque adjustment ring.

 Place the hooks over the mounting ribs, making sure the

hooks are positioned in the slots as shown.

NOTE: Make sure the notches on the inside of the auxiliary

handle engage the tabs on the drill housing.

 Turn the handle grip clockwise to tighten. Make sure the

handle assembly is secure before beginning operation.

To remove the handle assembly and install it on the op-

posite side:

 Turn the handle grip counterclockwise to loosen and

remove the handle assembly.

 Reinstall the handle assembly in the desired position.