Operator`s manual

Ridge Tool Company
9
these procedures to reduce the risk of injury from
electrical shock, re and other causes and prevent
damage to the CS1000.
1� Check work area for:
• Adequate lighting�
• Flammable liquids, vapors or dust that may
ignite� If present, do not work in area until
sourceshavebeenidentiedandcorrected.
The CS1000 is not explosion proof� Electrical
connections can cause sparks�
• Clear, level, stable dry place for operator� Do
not use the machine while standing in water�
• Clear path to electrical outlet that does not
contain any potential sources of damage for
the power cord, when using external power�
2� Inspect the work to be done� If possible,
determine the drain access point(s), size(s)
and length(s) and presence of drain cleaning
chemicals or other chemicals, etc� If chemicals
are present, it is important to understand the
specic safety measures required to work
around those chemicals� Contact the chemical
manufacturer for required information�
3� Determine the correct equipment for the
application� The CS1000 is made to view and
record inspections done with a SeeSnake
inspection camera� Inspection equipment for
other applications can be found by consulting
the Ridge Tool Catalog, online at http://www�
RIDGID�com or http://www�RIDGID�eu�
4� Make sure all equipment has been properly
inspected�
5� Evaluate the work area and determine if any
barriers are needed to keep bystanders away�
Bystanders can distract the operator during
use.Ifworkingneartrafc,erectconesorother
barriers to alert drivers�
6� If needed, remove xture (water closet, sink,
etc�) to allow access�
Equipment Set Up
The CS1000 can be set up quickly and easily to keep
yourworkowmoving.
Placement
Place the CS1000 allow easy access and viewing
while manipulating the camera and pushrod for an
inspection� Set-up the CS1000 so its screen is easy to
see and adjust the controls so they are easy to reach
during use� In brightly lit areas, point the screen away
from bright light sources and/or use the monitor’s sun
shade to reduce glare� Make sure that the location is
not wet and will not let the CS1000 and other equipment
get wet during use� The CS1000 is not waterproof and
exposure to wet conditions can cause electrical shock
or equipment damage�
Place camera and reel as instructed in their Operator’s
Manual�
Tilt Stand
Use the tilt stand to customize the viewing angle of the
CS1000’s screen and the positioning of its keyboard�
Whether or not you use the tilt stand will depend on the
inspection environment and personal preference�
1� Place the CS1000 in the desired location�
2� Tilt the unit back slightly and pull forward on the
tilt stand located underneath the device until it
locks in place�
Figure 6 – Front Cover, Tilt Stand, Release Buttons
3� To store the tilt stand, tilt the unit back slightly
and push the tilt stand toward the back of the unit
untilitisatagainstthebottom.
Front Cover
The CS1000 Front Cover serves two purposes� It
protects the unit during transportation and storage
when not in use, and provides a sun hood to reduce
glare during inspections�