Specifications

13
Mounting Your Saw
1. From the bag labeled “Legs” remove the following
hardware:
4 Hex Head Screws, 5/16-18 x 1-1/4" Long
4 Hex Nuts, 5/16-18
4 Lockwashers, 5/16" External Type
8 Flat Washers, 11/32 x 11/16 x 1/16
2. Place the saw upside down onto a smooth piece of
cardboard or heavy paper, on the floor, so the saw is
resting on the table top.
WARNING: The saw is heavy. To reduce the risk of
back injury, get help to lift the saw. Hold the saw
close to your body. Bend your knees so you can lift
with your legs, not your back.
3. Place leg stand on saw so that holes in saw base and
leg stand line up and trim label is facing front.
4. Install screw, washers, lockwasher and nut as shown.
5. Tighten all leg stand and mounting hardware at this
time.
Bench Mounting
If you do not use the legset and prefer to mount the saw
on a bench, make sure that there is an opening in the top
of the bench the same size as the opening in the bottom
of the saw so that the sawdust can drop through. Recom-
mended working height is 33 to 37 inches from the top of
the saw table to the floor.
Hex Head Screw
Flat Washer
End Stiffener
Flat Washer
Lockwasher
Hex Nut
Saw Base
Leg
Stand
5/16-18 x 1-1/4 In.
Hex Head Screw
5/16-18
Hex Nut
5/16 In. External
Lockwasher
11/32 I.D.
Flat Washer
Cardboard
7/16 Dia.
11-1/4
13
15-3/4
16-3/4
1/2
Front of Saw
NOTE: All dimensions in inches
Opening
Mounting Holes
Bench
+
+
7/8
+
+