User's Manual

19
1200 Series SmartPanels 1.0 User Manual
01-000HB03EG-A10
3.2.3 Lever-Groups
The keys of the SmartPanel can be assigned into up to 16 groups.
For an easy identification each group has an separate group color.
The group color can be selected in Key Properties in the Director software: right-click on the respective key
> Properties > 'General' tab > 'Group color'.
The group color is indicated either in the key ring or in the display of the SmartPanel.
This setting is done in Panel Properties in the Director software: right-click on the respective SmartPanel >
Properties > 'UI Config' tab > 'Group color'.
figure 22: group color per key in Director (Key
Properties)
figure 23: indication of group color in Director (Panel
Properties)
The key signalization is indicated in the opposite way:
· If the group color is indicated via the key ring, the signalization is indicated via the display.
· If the group color is indicated via the display, the signalization is indicated via the key ring.
Group Color via Key Ring
Group Color via Display
Group-Color
(i.e. light blue)
Signalization
via the key ring
(only in Talk/Listen mode)
Signalization (Bars)
via the display
(only in Talk/Listen mode)
Group-Color
(i.e. light blue)
In Talk/Mute mode, signaling is always shown via icons in the key display.
3.2.4 Operation Mode
The RSP-1232HL offers two different ways of operation:
· Talk/Listen
· Talk/Mute
The desired mode can be set in the Director software (panel properties > 'UI Config' tab):
right-click on the respective SmartPanel > Properties > 'UI Config' tab > 'Panel operation mode'.
figure 24: workflow mode in Director
The following table shows the function of lever keys in both modes:
Lever Direction
Talk/Listen
Talk/Mute
up
*1
Listen to outgoing audio (Talk) on a
remote panel (monitor remote panel)
Mute the incoming audio signal
down
*2
· Talk to a panel
· Execute additional configured commands
*1
latching only
*2
auto, momentary and latching