User's Manual

25
1200 Series SmartPanels 1.0 User Manual
01-000HB03EG-A10
GPI IN port
The GPI input connector contains 3 single ports.
9 6
5 1
Pin
Signal
Pin
Signal
1
GP-IN1-P
6
GP-IN1-N
2
GP-IN2-P
7
GP-IN2-N
3
GP-IN3-P
8
GP-IN3-N
4
GPIO +5V
9
GND
5
Chassis
Chassis
Chassis
figure 44: GPI IN connector Sub-D-9 female pinout
GND
GPI-INn-P
GPI-INn-N
figure 45: GPI IN connector schematic
· The input voltage range of the GPI inputs is +5 to +48 VDC (~5 mA current draw, internal
optocouplers).
· The polarity of the inputs is important. The higher potential must be connected to “P” of each
channel.
· The inputs are galvanically isolated.
· The "GPIO +5V" output voltage drops by increasing the load: 5V @ 0mA / 3.3V @ 50mA.
GPI OUT port
The GPI output connector contains 3 single ports.
6 9
1 5
Pin
Signal
Pin
Signal
1
GP-OUT1-P
6
GP-OUT1-N
2
GP-OUT2-P
7
GP-OUT2-N
3
GP-OUT3-P
8
GP-OUT3-N
4
--
9
--
5
Chassis
Chassis
Chassis
figure 46: GPI OUT connector Sub-D-9 male pinout
GND
GPI-OUTn-P
GPI-OUTn-N
figure 47: GPI OUT connector schematic
· The GPI output contact rating is 300 mA, 60 VDC maximum (protected by self-healing fuse).
· The polarity of the output has no preference.
· The outputs are galvanically isolated.
· The "GPIO +5V" output voltage drops by increasing the load: 5V @ 0mA / 3.3V @ 50mA.