User`s manual

2. SPECIFICATION
¾ Model No.: VST-RM588
¾ Operation Temperature: -10°C—50°C
¾ Power Source: 2*1.5V AA Batteries
¾ Standby Current: 10uA max
¾ Current Consumption: 35mA max
¾ Working Frequency: 433/868MHZ
¾ Ambient Humidity: 10%-95%
¾ Low-voltage Indication: ≤2.1V
¾ Unit Dimension: 88.0mmX88.0mmX27.5mm
3. INSTALLATION
1 Position the Remote Control Switch 1.2 metres (approx) up on a wall in a suitable position on an exit route.
Avoid locating near metal objects.
2 Securely attach the mounting box of the unit to the wall using the fixing screws supplied.
3 Find the 4-position dipswitch located on the back of Remote (see picture 1).
4 Define the ID of your system by positioning the switches of the dipswitch in a random pattern. The ID will
need to be the same for each alarm. This ID will differentiate your alarm system from similar systems nearby.
See section 4 “
HOW TO SET THE WIRELESS INTERCONNECTION FUNCTION ”.
5 Using a pen or pencil, Slid the switches in each of the wireless devices to match the pattern you selected in
step 4. Ensure that the sequence is not reversed
6 Insert 2 AA batteries to compartment. NOTE POLARITY OF CONNECTIONS. (see picture 1)
7 When the batteries have been fitted, The VST-RM588 green light indicator will flash in sequence to indicate
power-up.
8 Fix the Remote Control Switch assembly to the mounting box.
9 Using the Test switch, verify that the Remote Control Switch activates all the alarms in the system. (If asome
of the alarms have not been activated, then the ID coding procedure should be repeated. If there are still some
problem, see the section 5 on “Troubleshooting RF LINK” ).
Picture 1 Picture 2
3. USING REMOTE CONTROL