User`s manual

FOLLOW THE ID SETUP STEPS
1. Remove the battery.
2. Press and hold the Test button for a minimum of 10 seconds.
3. Find the 4-position dipswitch located on the device.
4. Select one of the units. You will define the ID of your system by positioning the switches of the
dipswitch in a random pattern. The ID will need to be the same for each alarm. This ID will differentiate
your alarm system from similar systems nearby.(refer to TABLE 1)
5. Using a pen or pencil, change the switches in each of the wireless devices to match the pattern you
selected in step 3. Ensure that the sequence is not reversed.
6. Insert 2 AA battery to the compartment. NOTE POLARITY OF CONNECTIONS. The unit only read
the ID that has been set when they are first supplied power. Any changes to the switch after the unit is
powered will not be recognized, and will require the power to be removed, Press and hold the Test
button for a minimum of 10 seconds before powering again.
7. Fix the Remote Control Switch assembly to the mounting box.
8. Push test button to test the Remote Control Switch.
5.TROUBLE SHOOTING RF LINK
If, when checking the RadioLINK interconnection, some of the alarms do not respond to the Remote Control
Switch TEST button, then:
(i) Ensure the Remote Control Switch has been activated correctly and the RF indicator red light has come
on continuously for 10 seconds
TABLE1
1~4 ID 1~4 ID
0000 0 1000 8
0001 1 1001 9
0010 2 1010 10
0011 3 1011 11
0100 4 1100 12
0101 5 1101 13
0110 6 1110 14
0111 7 1111 15