User's Manual

BMD-300 Series Module Datasheet
Bluetooth 4.2 LE
October 20, 2016
BMD-300-Series-DS V1.7 Page 30 of 34
15.7 Australia / New Zealand
The BMD-300 Series modules have been tested to comply with the AS/NZS 4268 :2012+AMDT 1:2013, Radio
equipment and systems – Short range devices – Limits and methods of measurement. The report may be
downloaded from www.rigado.com, and may be used as evidence in obtaining permission to use the RCM.
Information on registration as a Responsible Party, license and labeling requirements may be found at the
following websites:
Australia: http://www.acma.gov.au/theACMA/radiocommunications-short-range-devices-standard-2004
New Zealand: http://www.rsm.govt.nz/compliance
The A-Tick and C-Tick marks are being migrated to the Regulatory Compliance Mark (RCM). Only Australian-
based and New Zealand-based companies who are registered may be granted permission to use the RCM. An
Australian-based or New Zealand-based agent or importer may also register as a Responsible Party to use the
RCM on behalf of a company not in Australia or New Zealand.
15.8 Approved External Antennas
The antennas listed below were tested for use with the BMD-301.
#
Manufacturer
Part Number
Max Gain
Type
Size
Approvals
1
Pulse
W1030
2 dBi
1/4 Wave Dipole – Whip
Length: 108.3mm
FCC, IC, MIC
2
Taoglas
FXP73.07.0100A
2.5dBi
1/4 Wave Dipole – Flex
7mm x 47mm x 0.1mm
FCC, IC, MIC
3
Pulse
W1027
3.2 dBi
1/4 Wave Dipole – Whip
Length: 136.8mm
FCC, IC, MIC
4
Kinsun
6670113050-145
2.0 dBi
1/4 Wave Dipole – PCB
12mm x 65mm x 0.46mm
FCC, IC, MIC
5
Kinsun
6610103081
5.0 dBi
1/2 Wave Dipole – Whip
Length: 196.6mm
FCC, IC, MIC
Table 12 - Approved External Antennas
15.9 BMD-350 Module Labeling
Due to the extreme size constraints, the FCC and IC have granted an exemption for the BMD-350 module from
requiring the FCC ID and IC number to be physically located on the module. However, the host product is still
required to affixed the FCC ID: 2AA9B05 and IC: 12208A-05 to the outside of the host product and in the user
manual. See Section 5.2 FCC Important Notes and Section 5.4 IC Important Notes for host product and user
manual labeling instructions.