User's Manual
Table Of Contents
- 1. Features
- 2. Applications
- 3. Ordering Information
- 4. Block Diagram
- 5. Quick Specifications
- 6. Pin Descriptions
- 7. Electrical Specifications
- 8. Firmware
- 9. Mechanical Data
- 10. Module Marking
- 11. RF Design Notes
- 12. Evaluation Boards
- 13. Solution Services
- 14. Bluetooth Qualification
- 15. Regulatory Statements
- 16. Solder Reflow Temperature-Time Profile
- 17. Packaging and Labeling
- 18. Cautions
- 19. Life Support Policy
- 20. Document History
- 21. Related Documents
BMD-330 Module Datasheet
Bluetooth 5
September 13, 2017
BMD-330-DS V0.9 Preliminary – Subject to Change Page 18 of 24
(2) Co-location Warning:
This device and its antenna(s) must not be co-located or operating in conjunction with any other transmitter
antenna.
(3) OEM integration instructions：
This device is intended only for OEM integrators under the following conditions:
The antenna and transmitter must not be co-located with any other transmitter or antenna. The module shall
be only used with the integral antenna(s) that has been originally tested and certified with this module.
As long as the two (2) conditions above are met, further transmitter testing will not be required. However, the
OEM integrator is still responsible for testing their end-product for any additional compliance requirements
with this module installed (for example, digital device emission, PC peripheral requirements, etc.)
In the event that these conditions cannot be met (for example certain laptop configuration or co-location with
another transmitter), then the FCC authorization for this module in combination with the host equipment is
no longer considered valid and the FCC ID of the module cannot be used on the final product. In these and
circumstance, the OEM integrator will be responsible for re-evaluating the end product (including the
transmitter) and obtaining a separate FCC authorization.
Caution!
The OEM is still responsible for verifying end product compliance with FCC Part 15, subpart B limits for
unintentional radiators through an accredited test facility.
(4) End product labeling：
The final end product must be labeled in a visible area with the following:
• “Contains FCC ID: 2AA9B09”
• Any similar wording that expresses the same meaning may be used.
The FCC Statement below should also be included on the label. When not possible, the FCC Statement should
be included in the User Manual of the host device.
“This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions. (1) This device may not cause harmful
interference. (2) This device must accept any interference received, including interference that may
cause undesired operation.”
(5) Information regarding the end user manual：
The OEM integrator has to be aware not to provide information to the end user regarding how to install or
remove this RF module in the user’s manual of the end product which integrates this module. The end user
manual shall include all required regulatory information/warning as show in this manual (Section 15.2(4)).