User's Manual
Table Of Contents
- 1. Features
- 2. Applications
- 3. Ordering Information
- 4. Block Diagram
- 5. Quick Specifications
- 6. Pin Descriptions
- 7. Electrical Specifications
- 8. Firmware
- 9. Mechanical Data
- 10. Module Marking
- 11. RF Design Notes
- 12. Evaluation Boards
- 13. Solution Services
- 14. Bluetooth Qualification
- 15. Regulatory Statements
- 16. Solder Reflow Temperature-Time Profile
- 17. Packaging and Labeling
- 18. Cautions
- 19. Life Support Policy
- 20. Document History
- 21. Related Documents
BMD-330 Module Datasheet
Bluetooth 5
September 13, 2017
BMD-330-DS V0.9 Preliminary – Subject to Change Page 20 of 24
15.5 CE Regulatory
The BMD-330 module is being tested and is expected to be compliant against the following standards. OEM
integrators should consult with qualified test house to verify all regulatory requirements have been met for
their complete device.
From Directive 2006/95/EC:
• EN 60950-1: 2006 + A11: 2009 + A1: 2010 + A12: 2011
From R&TTE Directive 1999/5/EC:
• ETSI EN 300 328 V 2.1.1
From Directive 2004/108/EC:
• ETSI EN 301 489-1 V2.1.1
• ETSI EN 301 489-17 V3.1.1
Declarations of Conformity and supporting test reports are available at www.rigado.com.
15.6 Australia / New Zealand
The BMD-330 module has been tested to comply with the AS/NZS 4268 :2012+AMDT 1:2013, Radio
equipment and systems – Short range devices – Limits and methods of measurement. The report may be
downloaded from www.rigado.com, and may be used as evidence in obtaining permission to use the RCM.
Information on registration as a Responsible Party, license and labeling requirements may be found at the
following websites:
Australia: http://www.acma.gov.au/theACMA/radiocommunications-short-range-devices-standard-2004
New Zealand: http://www.rsm.govt.nz/compliance
The A-Tick and C-Tick marks are being migrated to the Regulatory Compliance Mark (RCM). Only Australian-
based and New Zealand-based companies who are registered may be granted permission to use the RCM. An
Australian-based or New Zealand-based agent or importer may also register as a Responsible Party to use the
RCM on behalf of a company not in Australia or New Zealand.