User's Guide
FCC RF exposure compliance requirements, a separation distance of at least 20 cm should be
maintained between the antenna of Openpath Smart Reader(s) and persons during operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
OP-RLF-STD/MULB: FCC ID: 2APJVOPRLF
OP-RHF-STD/MULB: FCC ID: 2APJVOPRHF
IEC 62368-1
● This equipment is intended only for use in a restricted access area.
● Securely fasten the equipment according to LifeSafety Power mounting instructions. See
FlexPower Vantage Standard Power System - Installation Manual.
● PROTECTIVE EARTHING: For safety, the Smart Hub must only be plugged into a grounded
3-prong outlet, wired with a minimum of 16 gauge wire to ground.
Version 1.9
©
Openpath 2019
Page 43