Installation Guide
Regulatory
All national and local electrical codes apply.
UL 294
When the Openpath Smart Hub 4 Door Controller is enclosed in the E1 enclosure and powered by
FPO75, the following performance levels are defined for the access control unit as per UL 294:
Attack:
Level I
Endurance:
Level I
Line Security:
Level I
Standby:
Level I
Single Point Locking Device with Key Locks:
Level I
CAN/ULC 60831-11-1-16 GRADE 1
For C-UL Listed applications, the unit shall be installed in accordance with Part 1 of the Canadian
Electrical Code.
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation. To comply with
FCC RF exposure compliance requirements, a separation distance of at least 20 cm should be
maintained between the antenna of Openpath Smart Reader(s) and persons during operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
IEC 62368-1
● This equipment is intended only for use in a restricted access area.
● Securely fasten the equipment according to LifeSafety Power mounting instructions. See
FlexPower Vantage Standard Power System - Installation Manual.
● PROTECTIVE EARTHING: For safety, the Smart Hub must only be plugged into a grounded
3-prong outlet, wired with a minimum of 16 gauge wire to ground.
Version 1.5
©
Openpath 2019
Page 17